Programs 2-5 - TESTO 324 Instruction Manual

6.2.8.2.

Programs 2-5

Four measurement programs for different measurement types can
be configured and enabled. The measurement programs are used
to save and represent measuring sequences. At the end of the
measuring process, the measuring values of a measurement
program are automatically saved in a record.
Only one measurement program can be activated in the instrument.
Call up the function:
> [
Selecting and setting a program:
> Select and set program and then confirm with [Finished].
Setting options:
Parameter
Program
Configure
measurement
view
Meastime
Measuring rate
] → Measurements
Function
1. Select the program: [▲],
2. Edit program name: →
and sometimes [◄],
3. Save changes: [Finished].
1. Select the program: [▲],
2. Select
3. Select parameter: [▲],
(enabled),
4. Save changes: [Finished].
1. Select the program: [▲],
2. Select
3. Enter values. [▲],
[►]
4. Save changes: [OK].
The measuring rate is the storage cycle for
mean values It is programmed in units of
seconds, minutes, whereby the smallest
possible measuring rate depends on the
number and type of connected probes.
1. Select the program: [▲],
2. Select
3. Enter values. [▲],
[►]
4. Save changes: [OK].
→ [OK] → Programs
[►]
Measurement
[ ] (disabled), tee table below
Gas time: [▼]
[▼]
→ [OK].
Measuring rate:
[▼]
→ [OK].
6 Using the product
→ [OK].
[▼] → [Edit].
[Edit] → [▲], [▼]
→ [OK].
[▼] → [Edit].
view: [▼] → [Edit].
[▼] → [ ]
[▼] → [Edit].
→ [Edit].
and sometimes [◄],
[▼] → [Edit].
[▼], [►] → [Edit].
and sometimes [◄],
65