Remove The Turbocharger - ABB TPL85-B14 Operation Manual

7.2
7.2
CAUTION
© Copyright 2016 ABB. All rights reserved.
Removal and installation

Remove the turbocharger

Remove the turbocharger
Disconnect all gas, air and oil lines in accordance with engine builder's

instructions.
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be en-
sured that the orifice plates that are specified for the turbocharger have
been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.

Unplug cable connector on speed sensor.

Remove insulating shell from bearing casing.

Fasten each of two sets of lifting gear to each of two bearing casing

ribs provided for this purpose.
Unscrew fixing screws in foot.

Lift turbocharger off engine and put it down to one side.

Operation Manual / TPL85-B14/-B15/-B16
7
7.2 Page 86