ABB TPL85-B14 Operation Manual page 104

If necessary
WARNING
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Removing internal part of compressor
casing
Attach two shackles (90195) to the support angle (90025) and fasten a

second set of lifting gear to both shackles (90195).
Slightly raise the compressor casing internal part (76000) along with

the wall insert and diffuser using the lifting device (90190).
Use a second set of lifting gear to carefully move the compressor cas-

ing internal part (76000) into a vertical position.
Set down the casing with the flange (F) on an underlay.

Make sure that the underlay does not slip.
Allow the compressor casing internal part to rest only on the flange (F).

Check underlay and adjust if necessary.

Operation Manual / TPL85-B14/-B15/-B16
8
8.6 Page 102