ABB TPL85-B14 Operation Manual page 61

5.4.1
NOTICE
Operating the water pres-
sure vessel
© Copyright 2016 ABB. All rights reserved.
Maintenance
Cleaning the compressor during
operation
Wet cleaning using external water-pressure vessel (XC3)
Operating state prerequisites for compressor cleaning with XC3
In order to carry out a successful cleaning procedure which has been
tested and is recommended by ABB Turbo Systems, the following pre-
requisite must be met:
Engine load 25 to 85 %

Start the cleaning cycle according to following description Wet clean-

ing procedure with XC3.
Compressor wet cleaning procedure with XC3
It is mandatory to fulfil the operating condition prerequisites before

cleaning compressors with XC3.
Remove the sealing plug (X).

Fill the vessel with the required volume of clean water (see the Table

of cleaning parameters).
Operation Manual / TPL85-B14/-B15/-B16
5
5.4 Page 59