Fitting Internal Part Of Compressor Casing - ABB TPL85-B14 Operation Manual

8.9
8.9
Fitting the diffuser
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Fitting internal part of compressor
casing

Fitting internal part of compressor casing

Fit O-rings (77005, 77006) to wall insert (77000).

Attach lifting gear and fit swivel lifting eyes (90230).

Align wall insert (77000) with threaded holes in internal part (76000) of

compressor casing using dog points on swivel lifting eyes (90230) and
then lower it.
Loop lifting gear around diffuser (79000), align it with holes and put

down into position.
Tighten screws (76002) as far as they will go and then back them off a

¼ turn. Leave screws loose and diffuser moveable.
Fasten lifting gear to lifting device (90190) and shackles (90195) of

support angle (90025).
Operation Manual / TPL85-B14/-B15/-B16
8
8.9 Page 106