Envelope Does Not Seal; Insufficient Or Partial Sealing; Envelope Does Not Eject; Envelopes Do Not Stay In Catcher Tray - Pitney Bowes E589 Series Operating Manual

Troubleshooting

Envelope Does Not Seal

Indicator Light
Print + Seal or
Only
Indicator Light
Print Only

Insufficient Or Partial Sealing

Indicator Light
None

Envelope Does Not Eject

Indicator Light
None

Envelopes Do Not Stay In Catcher Tray

Indicator Light
None
20
Cause
Seal
Fluid bottle is out of
®
E-Z Seal solution.
Cause
User did not press Seal
Only or Print + Seal
before feeding envelope.
Machine reset to Print
Only after not being
used for more than 30
seconds.
Cause
Sealer brush dirty.
Cause
Catcher tray is full.
Ejector rollers not set
properly.
Cause
Catcher tray not
positioned properly.
Solution
®
Add E-Z Seal solution.
For more information see
page 14.
Solution
Press Seal Only and
refeed.
Solution
Lift tab and slide
sealer brush
toward you to
remove. Clean by
rinsing with
warm water.
Solution
Empty catcher tray.
Adjust ejector rollers.
For more information
see page 16.
Solution
Adjust catcher tray.
SV60975 Rev A