FINE mechatronics FS-8000 Instruction Manual page 8

☞ PRINT Key
* Unavailable to work it while Auto Mode
* Please push
Only Unavailable to re-power,change the PART,Available 1time only
(The last total data will be deleted also on Auto-total)
☞ CLR
Key : This have 4way to use as folllows .
1) When cancelling it with inputing the setting value
CLR + TOTAL(+TOTAL) +SET
2)
CLR + Print when deleting the last TOTAL date
3)
4) When using SETUP or CALIBRATION ( 3Chapter, 4Chapter REFERENCE)
CLR Key,If no a addtional data,it will be deleted automatically.
* After
☞ SET/CAL
1) When recording each setted data
2) When using SETUP or CALIBRATION( 3Chapter, 4Chapter REFERENCE)
---------------------------------------------------------------------------------
FINE MECHATRONICS
: This Key is to Transmit,Totalize,Print a DATA
CLR + Print when deleting the last TOTAL date
SET
Key : key have 2way to use as follows
FS8000
When setting the total data.
.
.
8