Rs-232C Serial Interface - FINE mechatronics FS-8000 Instruction Manual

F36-

5-3-1. RS-232C SERIAL INTERFACE

RS-232C Interface is the system that transmit the signal by Voltage Volume and is sensitive to the Noise.so
you must install AC Power Cable or Electric Wire separately also the cable must be used with Shield Coax
Cable.
The Recommand Distance must be in 10M.
SIGNAL FORMAT
▩
- Signal Type
- Transmittion Method : FULL-Duplex, Asynchronous
- Baud rate : 300, 600, 1200, 2400, 4800, 9600, 14.4k, 19.2k, 28.8k, 38.4kbps
- Bit Format ⓐ Data bit
ⓑ Stop bit
ⓒ Parity bit
ⓓ Code
0 +10V
1 -10V
STREAM MODE
▩
It is doing Data Output in Stream Mode whenever A/D Converts
Refer)
A/D Conversion : Appr.25times/sec in lower weight.
A/D Conversion : Appr.15times/sec in Heavy Duty weight.
---------------------------------------------------------------------------------
FINE MECHATRONICS
INTERFACE TYPE CHOICE FOR WEIGHT
Transmitting the same Weight with the weight of dispaly
1 Transmitting a final Weight
2 Tranmitting Gross Weight Only
3 Tranmitting Net
: EIA RS-232C
: 7 or 8 (No parity)
: 1 Bit
: EVEN,ODD,NONE
: ASCII
LSB
0 1 2
↑ ↘
Start bit
FS8000
Weight Only
MSB
3 4 5
Data Bit ↙
6
↑ ↘Stop 1 Bit
Parity bit
or MSB 7
38