Table of Contents
Advertisement
F24-
Additional Reference
F25-
F26-
---------------------------------------------------------------------------------
FINE MECHATRONICS
Auto S/T,G/T in case of HOLD MODE
1
Auto HOLD Function (In case F25-00,01 it is unavailable)
2
Auto HOLD Function & Empty HOLD Auto Remove
3
Auto S/T,G/T on a steady Lamp
4
Auto S/T,G/T when a steady weight was in Empty area.
0 : The function to totalize when setting the HOLD on auto display
[ It can use it in totalizing and fixing it at the present weight
According to USER.
1 : The function to operate HOLD command and display automatically
To satify F25 without separate HOLD command.
[Whe USER use always HOLD INPUT,This function will be effective.
2 : The same as the above,when it was EMPTY range,
The HOLD command removes and turn out.
[The same as the above function, But
The HOLD remove automaticallly).
3 : It auto-totalize displaying a steady while weighing the weight.
[Available to record the weight and to print it.
4 : After displaying the last steady Lamp while weighing it,
When the Empty range will be after removing the products,
Then the last steady Lam`s weight will be totalized.
[The function to totalize it without printer KEY.)
Holding the present weight as setting HOLD KEY.
1
Holding a balanced weight for a steady judment delay time
2
When a steady lamp was displayed
3
When maxium weight was displayed(1 time)
Holding a weight when Maxium weight was displayed
4
when Maxium weight was renew.
NOMINATION CODE NUMBER
FIXING
1
1 Increase after weighing 1time
1 Decrease after weighing 1time
2
FS8000
SET AUTO FUNCTION
SET HOLD FUNCTION
( "0" is No Decrease)
And
35
Hide quick links:
Advertisement
Table of Contents
