FINE mechatronics FS-8000 Instruction Manual page 21

▶ HOW TO ADJUST SPAN.
S&C MODE have 7way to adjust span. eahc step will be advanced with
SET/CAL key.
Also,
※ F.F
※ Review
☞ 1Step.
A step to set up a division value and decimal point.
"d" menas "Division"and "xx" means a division capable of displaying.
Also this value wll be displayed as 01-02-05-10-20-50 by each key.
In case decimal point is "0.0",it will be 2
In case decimal point is "0.00",it will be 3
In case decimal point is "0.000",it will be 4
If decimal not,push 1key and
So,it will be go to the next step recording the position of decimal point.
☞ 2Step
A step to set up max.weight.
The display will appear
It can input the maxium weight as the end-user demands instead of discretion number.
How to input is to push
♣ Don`t excess (A division ÷ Max.weight) with over
If excessing over 1/20,000,it wll appear
☞ 3Step
A step to check the zero conditions of Indicator.
"dEAd"
After appearing
If the present number is closed by 5,000,please push
If a discretion number don`t appear and is over 20000,
Please do it as the zero adjustment instruction.
---------------------------------------------------------------------------------
FINE MECHATRONICS
CLR
key was used to return the prior conditions.
SET/CAL
: key
CLR
: key
SET/CAL key,
"CAPA"(
Capacity) and discretion number
SET/CAL
key after inputting discretion number.
,the discretion number(Max.5figure) will appear.
FS8000
1/20,000
"Err 01"
.
SET/CAL key.
(max.6figure)
21