Chapter 3.Calibration; Zero Adjustment - FINE mechatronics FS-8000 Instruction Manual

CHAPTER 3.CALIBRATION

▣ What is Calibration?
Cablibration is to adjust Max.weight,minium division,decimal point displaied to Indicator
To the actual weight worked by load cell.
☞
It should calibrated certainly when load cell or indicator will be changed.

3-1. ZERO ADJUSTMENT

▣ What is zero adjustment.?
The meaning of ZERO is the fiducial point of weighing operation.
In case a zero value is less than normal operating zero range,
The indicator will be displayed to
The other side, it will be displayed to
Then,it will be not operated normally
☞ ZERO POINT RANGE
Adjust the value displayed to
( Dip-switch 1-6 )
※ ZERO POINT ADJUSTMENT REFERENCE AS FOLLOWS
1. HOW TO ADJUST ZERO POINT
Please turn on while pushing
The display was displayed as follows
key
Push again,Indicator displays zero value after displaying
Then,if an zero value was not displayed or displayed with
Or not Displayed any number,Turn on the dip-switch(1~6)of the real panel,
Adjust the dip-switch that The number appearing on the display should be closed to 5000.
(Example)
While pushing
While displaying tESt + key,puse
Then this value will be zero value.
---------------------------------------------------------------------------------
FINE MECHATRONICS
"UL".
"bAd".
"test1"
closed to 1000 - 20000 (Recommand5000)
key
after turn off
tESt
key + Power turn on -> tESt
FS8000
"test1"
"test1"
only
key again.
18