Chapter 4. Set-Up; Preface; Set-Up - FINE mechatronics FS-8000 Instruction Manual

CHAPTER 4. SET-UP

4-1. PREFACE

" SET-UP " is to choose each proper functions for matching the indicator with the appliances of field.
▣ How to enter into set-up mode
This set-up mode is required for proper weighing operation when Indicator connects
With other appliance. It can enter into sep-up mode by the below two steps.
☞ The first Step
Depress key "
At that time,
Depress key "
At this time,press CLR key.
Indicator will display to " F01-xx " from above test message.
* For example
The power was OFF
1. Power "ON" while pushing
2. Pushing
CLR key
3. Push
☞ The second Step
If you depress key " SET/CAL" for 3 seconds at the normal weighing mode,
Indicator will also display

4-2.SET-UP

CLR
① If it press
"F01-xx"
The F of
And the last 2figure
* For example
Pushing CLR key in
F01-01
Function number will be increased to the next Function whenever it pushes .
② If you proceed to next function,press CLR key or,
If you want to see your desirous any function number,
Press "CLR" key after input any function number by numeric key.
Indicator will display function number directly from present function number.
---------------------------------------------------------------------------------
FINE MECHATRONICS
key
" first and power on at the same time.
"tESt"
word will be displayed on indicator.
key
"again, and indicator will display as following :
S t, C A L.
key
key
again
"St. CAL"
key at S&C Mode,Indicator will display
means Function and 01 means Function number
" xx"
- means each functional setting number
"St. CAL"
mode
FS8000
"tESt"
---------
"St. CAL"
---------
"F01 - xx"
---------
as the above.
"F01-xx"
; S & C Mode
27