Chapter 5. Set-Up Illustration; Basic Function For Weighing - FINE mechatronics FS-8000 Instruction Manual

CHAPTER 5. SET-UP ILLUSTRATION

5-1. BASIC FUNCTION FOR WEIGHING

F00-
F01-
F02-
※ NORMAL Condition is unavilable to back up the weight on the weighing part
In No power or OFF So,please turn on the power after removing it
※ BACK-UP menas that the weight weighing in OFF keeps the weight
When the power turns on
(KEY) Set BACK-UP MODE after adjusting the weight on NORMAL condition
F03-
※ What is ZERO Tracking ?
If A weight continue to change with a small value,
It displays the weight in spite of No product on the weighing part.
It is to compensate such a value.
F04-
When the weight change`s difference was in the range set for a time,
This function will make it safty.
If the factory environment have much vibration,pleae enlarge the motion band.
Also,if it was lower,please make it smaller.
---------------------------------------------------------------------------------
FINE MECHATRONICS
kg
1 ton
NORMAL
1 BACK-UP
SET ZERO TRACKING RANGE
0 No ZERO TRACKING
0.5DIGIT / 0.25sec
2 1DIGIT / 0.25sec
3 2DIGIT / 0.25sec
SET SAFTY MOTION BAND
0
2
3
4
FS8000
S&C MODE 전환
SET UNIT WEIGHT
WEIGHT BACK-UP
0.5 Devision
※ Motion Band ?
1 Devision
It means compensating a
termpoary tramble
2 Devision
If the weight change was less than
the present set value for the time set
4 Devision
by F-08, it will be a safty jusding.
8 Devision
30