Installing The Blower Housing On The Adapter; Installing The Lever For Cleaning Heating Surfaces - Windhager logwin premium touch Installation Instructions Manual

2. For the installer

2.3.18 Installing the blower housing on the adapter

– Only for LogWIN with flue connection adapter (accessories)
– First screw the 4 included M8x16 hexagon screws into the blower housing from the inside. the attach the blower
housing with seal. 4 nuts and washers to the adapter – Fig. 59.
Fig. 59 Installing the blower housing on the adapter

2.3.19 Installing the lever for cleaning heating surfaces

– Depending on accessibility. either install lever for cleaning heating surfaces on the left or right side. Punch through
the cut-out. insert lever through opening in side panel (Fig. 60) and slide inwards through the cleaning heating sur-
faces axle (limit stop must face upwards – Fig. 61) and secure with an M8x30 cylinder screw with hexagon socket
(inserted only) – Fig. 61. Push the grommet into the cladding on the side panel – Fig. 60.
Fig. 60 Punching through the cut-out. inserting lever
for cleaning heating surfaces through opening
Grommet
Fig. 61 Sliding lever through axle and securing
with screw (inserted only)
29
1 x
Limit stop