Installing The Flue Gas Blower. Air Control And Lambda Sensor; Installing The Lighting Door With Automatic Ignition - Windhager logwin premium touch Installation Instructions Manual

2. For the installer
2.3.8 Installing the fl ue gas blower. air control and lambda sensor
– Hook in the air control at the top and secure with screw at the bottom – Fig. 24. Fig. 26.
– Screw the lambda sensor in finger tight and tighten approx. 1/4 turn with an open-ended wrench (WAF 22) – Fig. 25.
Fig. 26.
– Screw the flue gas blower to the blower housing with 4 wing nuts – Fig. 26.
Fig. 24 Hooking in air control at the top and
screwing on at the bottom
Fig. 25 Lambda sensor installed

2.3.9 Installing the lighting door with automatic ignition

– Only for LogWIN with automatic ignition (accessories). see separate installation instructions (included).
Fig. 27 Automatic ignition
Fig. 26 Flue gas blower. air control and
lambda sensor installed
Fig. 28 Lighting door with automatic ignition
19
Flue gas blower
Air control
Lambda sensor