Profile Ash Removal; Correction Ash Removal; Limits For Blower Speed; Full Service - Windhager INFOWIN TOUCH Operating Manual

For the service technician/heating technician
27.2.7 Profi le ash removal
This parameter can be used to adjust the ash removal from the burner bowl for different levels of pellet quality.
Factory setting:
Setting range:
CAUTION Material losses
Restore factory setting for every delivery of pellets.

27.2.8 Correction ash removal

This parameter can be used to adjust the correction ash removal for different levels of pellet quality.
Factory setting:
Setting range:
CAUTION Material losses
Restore factory setting for every delivery of pellets.

27.2.9 Limits for blower speed

BioWIN 2 Touch
Factory setting: rpm
Setting range: rpm
BioWIN 2 Touch
Factory setting: rpm
Setting range: rpm

27.2.10 Full service

After a full service, the process has to be confirmed so that the operating time until the next full service is restarted.
Only displayed when „Service level" → „Settings" → „Full service" is set to ON.
CAUTION Material losses
Full service must not be reset if full service has not been carried out.
Very low ash content
low ash content
BioWIN 152
Minimum Maximum
800 2100
800 – 1200 2100 – 2500
BioWIN 262
Minimum Maximum
1050 2700
1050 – 1450 2700 – 2700
Stage 1
Stage 0
100 %
100 %
BioWIN 212
Minimum Maximum
900 2300
900 – 1300 2300 – 2700
BioWIN 332
Minimum Maximum
850 2200
850 – 1050 2200 – 2500
65
to Stage 3
Very high ash content
(possible formation of slag)
to 200 %
Very high ash content
(possible formation of slag)