Setting Up The Chip Priming Station - Agilent Technologies DNA 7500 Manual Kit

3
Setting up the Assay Equipment and Bioanalyzer

Setting up the Chip Priming Station

Setting up the Chip Priming Station
Replace the syringe with each new reagent kit.
N O T E
1 Replace the syringe:
2 Adjust the base plate:
3 Adjust the syringe clip:
8
a Unscrew the old syringe from the lid of the chip
priming station.
b Release the old syringe from the clip. Discard the old
syringe.
c Remove the plastic cap of the new syringe and insert it
into the clip.
d Slide it into the hole of the luer lock adapter and screw
it tightly to the chip priming station.
a Open the chip priming station by pulling the latch.
b Using a screwdriver, open the screw at the underside
of the base plate.
c Lift the base plate and insert it again in position C.
Retighten the screw.
a Release the lever of the clip and slide it up to the top
position.