Table of Contents
Advertisement
Chapter 5: Software, maintenance, support
5.4 Maintenance
Replace a hot-end
Because the nozzles are consumable parts, they eventually need replacement after hours of printing.
tential risk of injury, as the nozzle can reach temperatures of up to 275°C, so wait till temperature drops before handling.
4
1.
Retract the filament from the hot-end.
2.
Let the hot-end cool down.
The hot-end can reach 275°C so it is essential to do this step
poperly to avoid risk of injury.
3.
Turn off the printer.
FELIXprinters Quick Start Manual for the FELIX Pro 2 Touch
5
7
4.
Remove the edge connector of the hot-end.
5.
Open the fan cover.
6.
Put the tweezer in the top hole of the hot-end and take
the bottom of the hot-end with the other hand.
7.
Now gently pull out the hot-end forwards.
There is a po-
6
6
Page 24
Advertisement
Table of Contents
