Tips And Tricks - Felix printers Pro 2 Touch Quick Start Manual

Chapter 5: Software, maintenance, support

5.3 Tips and tricks

Before starting a print
Make sure the print bed is properly placed on its base.
»
Make sure filament is guided properly through the filament guide and filament spool holders.
»
Clean the print bed before starting every print.
»
» Clean the nozzles with the supplied tweezers before starting a print.
During a print
Make sure the first layer is printed properly before leaving the printer unattended. The first layer is the most
»
important layer and the basis of a print job. When this layer fails to be printed properly, the object could detach
and cause damage to the printer.
After the print job is finished
» Do not pull off an object from the print bed in a straight manner, always twist it from the build plate or use a
tool. For large objects it is recommended to take off the printbed and start peeling at the corners of the object.
Let the print bed cool down to about 30-40
»
print bed by just cooling down the print bed.
Other
» Never remove the heated print bed while the printer is heating.
» Never disconnect the display unit, while the printer is still on.
» When turning off the printer, make sure the heaters are cooled down below 100
FELIXprinters Quick Start Manual for the FELIX Pro 2 Touch
C before removing an object, sometimes an object can pop off the
0
C.
0
Page 23