11 Maintenance
A 3D printer is a quite complex motion system and requires maintenance.
TIP: Check our YouTube channel to see instruction video's about maintenance.
https://www.youtube.com/user/FELIXprinters
11.1 Motion system
The linear bearings require almost no maintenance. Recommended is that you put a little some grease
on them every 3-4 months.
The belt tension of the x and y axis can also be checked in intervals of 3 months. Check this small movie to
see how to tension the belts.
https://www.youtube.com/watch?v=dpS6nWn5rE8
40
Quick Start Guide FELIX BIOprinter
Page