Table of Contents
Advertisement
Figure 39. Removing a cabled drive
Next steps
1
Follow the procedure listed in
2
Install the internal drive bay into the chassis.
3
If disconnected, reconnect the power and data cable(s) to the remaining drive(s) in the internal drive bay.
Related link
Removing the internal hard drive bay
Installing the internal hard drive bay
Installing a cabled drive
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the internal drive bay.
Steps
1
Insert the drive into the internal drive bay with the drive connector facing outward.
2
Secure the drive to the internal drive bay using the four screws.
NOTE:
When installing new drives into the internal drive bay, use the spare drive screws attached to the drive bay.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
Installation and Service Manual
87
Advertisement
Table of Contents
