Dash Pod Switches; Bilge Pump - CORRECT CRAFT Ski Nautique Owner's Manual

Dash Pod Switches

There are function key switches to the right of the helm and surrounding the
keyless ignition keypad. These are waterproof momentary switches. By
pressing a function key, you activate the function indicated.
All of these switches interface with a sealed circuit breaker box located under
the bow. The circuit breaker box consists of sixteen soft opaque flexible vinyl
tubular shields which cover sixteen circuit switches. When the circuits are
functioning, the tubular shield is somewhat flexible. A tripped circuit breaker
will extend and fill the tubular shield, causing it to be inflexible. To locate a
tripped circuit breaker, run your fingers over the two rows of switches and
locate the switch shield that has become inflexible. To re-set, simply press in
the extended circuit switch shield.

Bilge Pump

The bilge pump switch turns on the bilge
pump. There is a bilge pump down by the
pylon. When you push the bilge pump
key on the keypad, the pump will come on
and run for several moments to "sense" of
there is water in the bilge. If there is water
in the bilge, it will remain on until the
water is pumped out. If there is no water in
the bilge, it will turn off. If you want
immediate pump action, turn the switch off
and then back on again. The pump will
turn on periodically to determine if there is
water in the bilge. If so, it will remain on
Bilge Pump
1.6 1.6