Class 2/3 Errors; Rs-232-C Controls; Setup Menu Key - Wavetek 75 Instruction Manual

Table 3-3. Class 1 Error Guldellnes 3.29.2 Class 2 Errors
Class 2 errors are parameter conflicts or inconsisten-
cies such as ABS (OFST)
+
peak amplitude greater than
5.2V. Tests are made every time an execute (I) is given.
If no class 2 error is detected, all scratchpad values are
transferred to the instrument setup.
This Parameter
ARB Address
ARB Data
Amplitude
Burst Count
Calibration
Clear Breakpoint
Hold
Mode
Offset
Ramp Rate
Ref
SRQ Mode
Sample Frequency
Set Breakpoint
Standard Waveform
Start Address
Stop Address
Sync Address
Talk Message
Terminator
Trigger Slope
3.29.3 Class 3 Errors
A class 3 error is a parameter conflict or inconsistency
between the Start Address, Stop Address, and Sync
Address parameters. Tests are made every time an
execute (I) is given. If no class 3 error is detected, all
scratchpad values are transferred to the instrument
setup.
Must (After Rounding) Be
0 to 8191
-
2047 to
+
2047
5E
-
3 to 5.1
1
to 1,048,575
-512 to +512
0 to 8191
0 to 1
0 to 4
-5.1 to +5.1
0 to 100
0 to 1
0 to 255
20E-3 to 2E+6
0 to 8191
0 to 8
0 to 8191
0 to 81 91
0 to 8191
0 to 7
0 to 127
0 to 1
3.30 RS-2324 CONTROLS
The RS-232C controls listed in paragraphs 3.30.1 thru
3.30.6 are referenced to figure 3-8, RS-232C Controls
and Switches.
3.30.1 Setup Menu Key (4)
Pressing this key five times enables the RS-232C com-
munication soft keys described below. The bottom line
of the display will then show the labels for these soft keys.
Paragraph 3.30.3
Figure 3-8. RS-232-C Controls and Switches
@
Paragraph 3.30.6
3-27
Scans by ArtekMedia O 2006