Enabling Or Disabling The Ribbon Near End Warning; Enabling Or Disabling The Label Pitch Re-Detection; Assigning The Function Button - SATO S8400 Operator's Manual

Table of Contents

Section 3: Configuration and Operation

3.11.14 Enabling or Disabling the Ribbon Near End Warning

This menu lets you enable or disable the re-detection of the label pitch whenever the printer is

turned OFF and then ON again, with the print head unlatched.

The default setting is ENABLE, where the printer will re-detect the

label pitch. Press the

buttons to choose DISABLE if you wish

to disable the sensing of a ribbon roll nearing the end of its supply.

Press the ENTER button to confirm the setting and proceed to the

next screen.

This menu lets you enable or disable the re-detection of the label pitch whenever the printer is

turned OFF and ON with the print head unlatched.

The default setting is ENABLE, where the printer will re-detect the

label pitch. Press the

buttons to choose DISABLE if you wish

to disable the sensing of a ribbon roll nearing the end of its supply.

Press the ENTER button to confirm the setting and proceed to the

next screen.

This menu lets you assign a function to the Function button. The NONE setting disables the

button. You can also choose to make the Function button issue a REPRINT command or use it to

switch to SEMBL MODE.

The default setting is NONE. Press the

buttons to choose

REPRINT or SEMBL MODE if desired.

Press the ENTER button to confirm the setting and proceed to the

next screen.

Page 3-28

S8400 Series Operator's Manual

Table of Contents