Hex Dump Mode; Entering Hex Dump Mode; Selecting Data To Dump; Controlling The Hex Dump Mode - SATO S8400 Operator's Manual

Table of Contents

3.9 HEX DUMP MODE

1. Press the LINE button to take the printer OFFLINE.

2. Press ENTER. The ONLINE MODE screen appears.

3. Press the

DUMP MODE", then press ENTER to perform the first setting. At

any time within this mode, pressing CANCEL takes you back

one screen. Pressing the FUNCTION button returns you

immediately to the main Hex Dump screen.

Here you can choose to dump either incoming data (receive data)

or print data already stored in the buffer (receive buffer) .

Press the

buttons to choose RECEIVE DATA, RECEIVE

BUFFER or INTERNAL DATA. Note that RECEIVE BUFFER

cannot be selected when there is no received data. The INTERNAL

DATA option refers to data stored in the printer buffer.

Press the ENTER button to confirm the setting and proceed to the

next screen.

During the HEX Dump, the following screen appears. The number

of labels printed will be shown. When printing is done, press the

LINE button to take the printer OFFLINE. Then press ENTER to

return to the main HEX DUMP Mode screen.

If you dumping the RECEIVE BUFFER, take the printer OFFLINE to

stop any incoming data from affecting the buffer. Only then can the

buffered data be printed. The printer goes ONLINE automatically

after the printing.

S8400 Series Operator's Manual

arrow buttons until you see words "HEX

Section 3: Configuration and Operation

Page 3-21

Table of Contents