Using The Dispenser - SATO S8400 Operator's Manual

2.3 LOADING LABELS AND TAGS (CONT'D)

2.3.2 Using the Dispenser

1. Load the paper as described in the previous section.
2. Now unlatch the Nip Roller (also called the Pressure
Roller) assembly by pressing the release latch as
indicated on the right.
3. Remove three or four labels from the label roll and
loop the liner from the print head area so that some
exposed liner is threaded into the nip roller. One label
will be half removed from the liner at the front of the
printer (see the cyan line for the liner path).
4. Press the Nip Roller assembly upwards and latch it
into place.
5. Latch the print head with the Head Lock level. To
check that the labels are dispensed properly, do a
paper feed. If necessary, go to User Mode to adjust
the paper offset for proper dispensing.
Caution
• When replacing paper, bear in mind that the print head and its surrounding area remain hot. Keep your fingers away from these
areas to prevent injury.
• Avoid touching even the edge of the print head with your bare hands.
S8400 Series Operator's Manual
Nip Roller
Release
Latch
Nip Roller
Release
Latch
Nip Roller
assembly
Fold liner into
nip roller
Latch the nip
roller assembly
The label
liner now
folds under
the label,
into the nip
roller
Section 2: Installation
Page 2-15