Loading Paper (Ribbon Cassette Installed) - SATO S8400 Operator's Manual

SECTION 2: INSTALLATION

2.3.1 Loading Paper (Ribbon Cassette installed)

1. Turn the blue head lock lever clockwise to allow
the ribbon cassette to be removed. Remove the
ribbon cassette and then push up the feed lock
lever.
2. Pull the label guide outward and guide the label roll
between the two halves of the Pitch Sensor
housing, and then under the print head. Make sure
the label runs parallel to the side of the printer. The
label should emerge at a perpendicular angle from
the print head.
4. Push the Label Guide lightly against the outside
edge of the label to restrict and straighten the label
path. The same applies to the innermost edge of
the label at the print head area of the body frame.
5. Push down the feed lock lever to lock the label
path in place.
7. Finally, latch the print head by turning the Head
Lock lever counterclockwise.
Caution
• When replacing paper, bear in mind that the print head and its
surrounding area remain hot. Keep your fingers away from these
areas to prevent injury.
• Avoid touching even the edge of the print head with your bare hands.
Page 2-14 S8400 Series Operator's Manual