Using The Auto Online Feature; Setting Print Offset - SATO S8400 Operator's Manual

Section 3: Configuration and Operation

3.8.14 Using the Auto Online Feature

The printer can be set to go into ONLINE mode automatically upon
being turned on. Otherwise, the printer starts in the OFFLINE state.
Press the / buttons to select YES or NO. The default setting is
YES.
Press the ENTER button to confirm the setting and proceed to the
next screen.

3.8.15 Setting Print Offset

The next screen allows you to set the Print Position Offset—which
refers to the vertical and horizontal shifting of the entire print area,
relative to the start position of printing (V=0, H=0), defined by
default to be the bottom right hand corner of the label.
Use the / buttons to select the V or H setting, and the
highlighted setting. Press the ENTER button to confirm a setting and proceed to the next screen.
The V setting is for the Vertical print offset. A positive (+) offset means the printing is shifted
towards the print head; a negative (-) offset means shifting away from the print head. If the Print
Pitch setting has been used to offset the vertical start position, then all Vertical offset adjustments
are made relative to that start position.
The H setting is for the Horizontal print offset. The + or - prefix
determines whether the offset is to the left or to the right of the
reference point.
Model Valid H and V settings (in dots)
S8408 V: +/- 000 to 1424 dots, H: +/- 000 to 832 dots
S8412
V: +/- 000 to
S8424
V: +/- 000 to
After setting the Vertical and Horizontal OFFSET, press ENTER
to proceed to the next setting.
Page 3-18
2136
dots, H: +/- 000 to
4272
dots, H: +/- 000 to
/
1248
dots
2496
dots
buttons to change a
Print head
H+
ref point 0,0
V+
Print offset
V-
S8400 Series Operator's Manual
H-