Assembling The Stand - Korg C-900 Owner's Manual

1. Controls and basic operation

Assembling the stand

Two or more persons are required in order to
assemble the instrument.
When placing the instrument on its stand, be careful
not to pinch your hand.
Carefully follow the assembly procedure, being
careful to place the correct part in the correct orien-
tation.
Be aware that if you apply excessive pressure to the
front of the instrument before tightening the screws,
the instrument may fall over.
1. You will need a Phillips (+) screwdriver (not
included).
2. Make sure that you have all the parts.
Side panel
•
Back panel
•
(left)
1
Pedal box
•
3
• In the plastic bag
✕4 5
• Long screws • Adjuster
(M6 x 75)
✕2 8
• Medium screws ✕2 9
• Adjustable bolts
(M6 x 20)
6
Caution
Side panel
•
4
(right)
6
• Short screws ✕10 7
(3.5 x 20)
0
• Cable holder
3. During assembly, be sure to place the back
of the stand on a flat floor surface etc. as
shown in the following diagram.
Align the left side panel
to the pedal box
fasten them together.
• Screw the adjuster 6 all the way
into the pedal box 3.
1
5
4. Partially screw three of the short screws
into the pedal box
2
7
5. Attach the back panel
Slide the slots of the back panel
that were partially inserted. Use six more short screws
to fasten the back panel
7
are drilled in the side panels. Completely tighten the
three short screws
the last short screw
• Finished surface toward the front
and the right side panel
1
, and use the four long screws
3
3
• Pull out the pedal cable.
.
3
3
• Approximately 8 mm
• Do not tighten the screws all the way.
• Do not put a screw here.
.
4
onto the screws
4
using the pilot holes that
4
which were left untightened. Use
7
to attach the cable holder
7
7
4
• Fit back panel 4 onto screws
• Fasten the cable holder 0 together with the
back panel
2
to
5
2
7
7
.
0