Korg Ci-9600 Owner's Manual page 94

Rotate the adjuster so that it firmly con-
tacts the floor.
If the adjuster is not in firm contact with
the floor, the pedal will wobble and cause
malfunctions.
5. Attach the decorative panels B to the side pan-
els.
Insert guide pins A of the decorative panels B
into the holes in the top board of the piano, and
insert guide pins B of the decorative panels B
into the holes in the side panel.
From inside the stand, use medium screws 9
to fasten the decorative panels. Left and right
panels are interchangeable.
A
B
6. Connect the pedal cable and power cable, and
fasten them.
Connect the power cable included with the
piano to the socket located on the back of the
instrument.
Place the piano at a distance from the wall,
so that the power supply cable on the back
panel is not strained.
94
• The power cable
connector is not polarized.
• Insert the pedal cable connector
into the pedal connector located
on the bottom of the piano. Be
sure that the connector is inserted
in the correct orientation.
• Use the cable holder to fasten
the pedal cable.
Check after assembly
● Are any parts left over?
If any parts are left over, check the diagrams to
see where they should be used.
● Are any of the assembly screws loose?
Make sure that all screws are tight.
Caution
Caution when moving
Take the piano off the stand, and transport the
stand and piano separately. After moving them,
refer to this manual, and re-assemble the stand
and piano.
Loosened screws
After the stand and piano are assembled, the
screws of the stand may become loose after
extended use, causing the stand to wobble. If this
occurs, re-tighten each of the screws in the stand.
Disassembly
To remove the piano and disassemble the stand,
reverse the order of assembly. After disassembly,
store all parts such as the screws so that they will
not be lost.