Omron C200H Operation Manual page 358

NOT
NSB
NSU
OFF
OFF delay
ON
ON delay
one-shot bit
on-line removal
operand
operand bit
operand word
operating error
Optical I/O Unit
Optical Slave Rack
OR
output
Glossary
A logic operation which inverts the status of the operand. For example, AND
NOT indicates an AND operation with the opposite of the actual status of the
operand bit.
An acronym for Network Service Board.
An acronym for Network Service Unit.
The status of an input or output when a signal is said not to be present. The
OFF state is generally represented by a low voltage or by non-conductivity,
but can be defined as the opposite of either.
The delay between the time when a signal is switched OFF (e.g., by an input
device or PC) and the time when the signal reaches a state readable as an
OFF signal (i.e., as no signal) by a receiving party (e.g., output device or
PC).
The status of an input or output when a signal is said to be present. The ON
state is generally represented by a high voltage or by conductivity, but can be
defined as the opposite of either.
The delay between the time when an ON signal is initiated (e.g., by an input
device or PC) and the time when the signal reaches a state readable as an
ON signal by a receiving party (e.g., output device or PC).
A bit that is turned ON or OFF for a specified interval of time which is longer
than one cycle.
Removing a Rack-mounted Unit for replacement or maintenance during PC
operation.
Bit(s) or word(s) designated as the data to be used for an instruction. An op-
erand can be input as a constant expressing the actual numeric value to be
used or as an address to express the location in memory of the data to be
used.
A bit designated as an operand for an instruction.
A word designated as an operand for an instruction.
An error that occurs during actual PC operation as opposed to an initializa-
tion error, which occurs before actual operations can begin.
A Unit that is connected in an Optical Remote I/O System to provide 8 I/O
points. Optical I/O Units are not mounted to a Rack.
A Slave Rack connected through an Optical Remote I/O Slave Unit.
A logic operation whereby the result is true if either of two premises is true, or
if both are true. In ladder-diagram programming the premises are usually ON/
OFF states of bits or the logical combination of such states called execution
conditions.
The signal sent from the PC to an external device. the term output is often
used abstractly or collectively to refer to outgoing signals.
355