Table of Contents
Advertisement
backlight off will increase battery life.
MENU / BACKLIGHT
3.8
Selecting a language
Your Covermeter has a number of built-in languages.
When the Covermeter is switched on for the first time after
dispatch from the Elcometer factory the display will show
the language selection screen (Figure 8).
At first switch on
1. Press [ ] or [ ] to locate language required.
2. Press [ ] to activate the selected language.
The Covermeter operates in the new language until
changed.
At any time
1. Switch Covermeter off.
2. Press and hold left hand softkey.
3. Press [
] to switch on Covermeter.
The display will show the language selection screen with the current language highlighted by
the cursor.
4. Release left hand softkey.
5. Press [ ] or [ ] to locate language required.
6. Press [ ] to activate the selected language.
Alternatively, select a language at any time.
MENU / SETUP / LANGUAGE
3.9 Computer interface
Your Covermeter is fitted with an RS232 interface. The interface is located under the interface
access cover at the rear of the Covermeter - see Figure 2 and Figure 3 on page 4.
This 5-pin RS232 interface is used with the data transfer cable
g
RS232 port
of a computer. When the Covermeter is connected to a computer you can:
•
Download personalised screens to the Covermeter (see "Personalised welcome screen" on
page 30).
3.10 Using the earphone
To use the earphone, plug the connector into the 3.5 mm socket marked
Covermeter. Replacement earphones are available as an optional accessory - see "Accessories"
on page 33.
f.
The data transfer cable is not included with Elcometer 331 Model B or BH. For ordering information, see
"Accessories" on page 33.
g.
An RS232 to USB transfer cable is available which allows you to connect your Covermeter to a USB port on
your computer. For ordering information, see "Accessories" on page 33.
G
ETTING STARTED
Figure 8. Language selection
screen
f
to connect the Covermeter to the
on the front of the
R
11
Advertisement
Table of Contents
