3.2
Assembly instructions
Before starting assembly, look carefully through the individual assembly steps shown
and assemble the equipment in the order indicated.
Step 1:
Assembly of the console mast and the front and rear base foot
(1) Slide the console mast cover (60) on the console mast (2). Make sure that the cover
points in the correct direction; see image. Slide the cable harness (80) from below up
through the console mast. During assembly of the console mast on the frame, make
sure that the cable harness does not get stuck or damaged.
(2) Mount the console mast on the frame with five screws (5/16"x 3/4") (32), four
washers (5/16) (33), five spring rings (5/16) (35) and one spring washer (5/16) (34).
Allow the console mast
cover (60) to lock on the
frame.
(3) Mount the front (4)
and rear base foot (5)
with four screws (5/16"
x 3/4") (32), four spring
rings (5/16) (35) and four
washers (5/16)(33).
Required
tool:
6mm
Allen wrench (87).
13