Prox 950 At A Glance; Prox 950 Center - 3D Systems ProX 950 User Manual

10

ProX 950 AT A GLANCE

ProX 950 CENTER

G
F
D
A
Polyray Printhead : The ProX 950 contains two IPMs. The IPM's are located at both sides on the top of the machine,
beneath the frame panels.
B
User Interface (UI): This is the control touchscreen which allows the user to interface with the the system. The
Print3D Pro software installed on the touchscreen enables the user to view and adjust the print parameters used to
print a part.
C
System Status Lights: System Status Lights indicate critical information regarding the system. See the section,
Indicators on page 14
D
Print Zone A: Print Zone A is located on the left side of the ProX 950, as you face the machine, and is utilized for the
printing of all machine configurations up to 30" wide.
E
Print Zone B: Print Zone B is located on the right side of the ProX 950, as you face the machine, and is utilized only for
print sizes over 30". If the print is over 30" it will be centered between the two zones.
F
Door Handle Locations: To open the doors, pull them by the handle-like grips at the edge of the door panel.
G
Light Stack: The light stack consists of three lights, red, yellow and green. The lights reflect what state the machine is
in at any given time.
3D Systems, Inc.
A
F
F
for descriptions of each indicator.
F
F
13
F
B
C
E
LED