Mdm Removal - 3D Systems ProX 950 User Manual

5. Once the MDM is in the machine, connect the cables in the front of the
MDM as shown.
6. Plug in the two I/O Connector in the first slot on both the right and left
side. The I/O connector is the large circular plug with the bundled gray
wires.
7. Next plug in the Serial Connector into the second receptacle. Align, push
in, and turn to lock.There is a serial connector on the right side and the
left side of the MDM. The left side Serial Connector connects the smart
technology reader for bottle on the left, and creates communication of
the heater to the vat. The right side Serial Connector only connects the
smart technology reader to the bottle on the right side.
8. There is a black three-pronged power cord that gets plugged into the
IEC receptacle . This connection enables the heater function of the MDM
allowing the material to heat up. After the connections are finished on
both the right and left side, flip up the power switch to enable power to
the MDM as shown.
9. The MDM is now installed, you can now close the print chamber doors.
10. Install elevator arms and print tray applicator.

MDM REMOVAL

The MDM is made of stainless steel and has eight casters for maneuvering it in and out
of the printer. There are also handles on the MDM that help the user to transport and
maneuver it in and out of the printer.
HOT SURFACE: The area underneath the MDM is hot—Do not reach
underneath!
To move the MDM out of the machine follow these steps:
1. Pump material into leveling reservoir.
2. Move the elevator to its lowest position so the forks can remain with the
MDM.
• Home the Print Applicator.
• Home the Elevator
• Move the Elevator down -10.
3. Open the print chamber doors.
4. Turn off the heater power switch and disconnect the AC power cord from
the electrical outlet.
5. Disconnect the following cables:
• Left Side: I/O Connection Cord and the Serial Connection Cable
• Right Side: I/O Connection Cord and the Serial Connection Cable
3D Systems, Inc.
46