3D Systems ProX 950 User Manual page 52

9. Once supports are removed, further rinse the
parts with Isopropyl Alcohol and blow-dry parts
with compressed air. Shop air with a dryer is
recommended; but you may also choose to do a
custom drying setup, such as the one with box fans
and absorbent cloth pictured at right.
10. Place parts into ProCure 1500 for final UV curing, using clear-glass shot glasses to stabilize the part (if necessary). Refer to the
ProCure 1500 UV Chamber User Guide
Build parts have been blurred for privacy.
11. If necessary, use sand paper to smooth out the bottom layer of your build, which was touching the bottom of the build
platform and supports.
Procedure is now complete .
3D Systems, Inc.
for more information on this process.
52
Build parts have been
blurred for privacy.