Omron NV Series Programming Manual page 198

Recipes
7. Transfer the recipe file to the PT.
8. Manipulate the control bits.
a. Specify the file number and block number.
Write 0 in W21 (file number) and 0 in W22 (block number) to specify
file 0 and block 0.
b. Turn ON the Write Bit.
Turn ON W20.00 (Write Bit).
c. Turn OFF W20.00 (Write Bit) when W20.08 (Write Complete Flag)
turns ON. Use the write address function or PLC ladder program to
manipulate these bits. W20.15 (Error Flag) will is OFF and W23 (Error
Code) is set to 0000 hex when operation is completed normally. The
values in block 0 set in step 5 is written to D200 to D209.
Section 8-5
Select PT – Transfer – Trans-
fer from the menu and select
the Recipe Check Box.
Note Enter the Recipe File
Number if required.
Example Transfer File Set-
tings
Recipe File Number
0, 1
Enter alphanumeric charac-
ters and place a comma
between file numbers. If noth-
ing is entered, all recipe files
will be transferred.
177