Omron NV Series Programming Manual page 110

Setting the NV Configuration from the NV-Designer
Note
Settings to Transfer Clock
Data to an External Device
(NV4W/NV3Q Only)
Note
System Menu Language
If using the PLC clock is selected, the PT will calculate clock data based on
the specified addresses in the PLC. If addresses that do not contain clock
data are specified, the PT will still use the contents of those addresses as
clock data. Be sure to check the correct clock data addresses in your PLC
manual and specify the correct addresses.
If the On Option is selected for Transfer Outside, a setting will appear to set
the first output address. Set the PLC memory area and address for transfer-
ring clock data.
If the On Option is selected for Transfer Outside, clock data will be transferred
to D0 as a default. The address can be reset according to the PLC that is con-
nected. Error ER1103 will occur if an address that does not exist in the PLC is
set.
The language for the System Menu can be selected from the following:
Japanese or English
Additional Information
With the NV4W/NV3Q, the System Menu language can be selected directly from
the System Menu.
If the On Option is selected for Transfer
Outside, this setting will be displayed.
Either enter the setting directly or click
the button on the right of the box and
enter the setting from the dialog box that
will appear.
Section 6-2
89