Omron NV Series Programming Manual page 148

Data Parts and Keyboard Parts
7. Enter text and frames into the data and keyboard parts.
8. Transfer the screen to the PT.
9. Check the display on the PT.
Section 7-7
After making the above set-
tings, enter "Update data
Change" on DA0 on the base
screen.
Next to KY0 on keyboard
screen 0, enter the text "Input
data" and then place a frame
around the text.
When data has been trans-
ferred, the parts created on
the NV-Designer will be dis-
played on the PT screen.
Touch the data part on the
panel to switch to the Input
data screen.
Enter a value, then touch the
ENT Key to return to the
Update data screen.
127