Control And Feedback Interface - Siemens SIMATIC ET 200SP Manual

Configuring/address space

4.5 Control and feedback interface

4.5 Control and feedback interface
Information on using the control and feedback interface can be found in the chapter
Configuring (Page 33).
A detailed description of the TM PosInput 1 control and feedback bits is available in the
Counting, measurement and position input function manual which can be downloaded from
the Internet (http://support.automation.siemens.com/WW/view/en/59709820).
Note
The control and feedback interface is compatible with the control and feedback interface of
the TM PosInput 2 technology module of the S7-1500 automation system.
Note
Operating with technology object
If you are using a technology object, the control and feedback interface is operated by the
technology object. This means you do not have to write directly to the control interface.
Fast Mode
If you are using the "Fast Mode" operating mode, a control interface is not available. The
feedback interface (Page 52) has an adapted assignment in Fast Mode. In addition, you can
find Explanations about the feedback bits (Page 52).
48
Technology module TM PosInput 1 (6ES7138-6BA00-0BA0)
Manual, 04/2016, A5E33015755-AC