Siemens SIMATIC ET 200SP Manual page 55

Meaning of the LED displays
The following tables explain the meaning of the status and error displays. Remedial
measures for diagnostic alarms can be found in the section Diagnostic messages (Page 62).
Table 5- 1 Status and error displays DIAG
LED DIAG
Backplane bus supply of the ET 200SP not OK
Off
Technology module not configured
Flashes
Technology module configured but no module
diagnostics
On
Technology module configured and module diag-
nostics (at least one error pending)
Flashes
Table 5- 2 PWR/24VDC status displays
LEDs
PWR 24VDC
Off Off
On On
On Off
Technology module TM PosInput 1 (6ES7138-6BA00-0BA0)
Manual, 04/2016, A5E33015755-AC
Meaning
Meaning
No supply voltage
Supply voltage is present and OK
Short-circuit or overload at the encoder
supply or supply voltage too low
Interrupts/diagnostic messages
5.1 Status and error displays
To correct or avoid errors
Check the supply voltage or turn it on at the inter-
face module.
---
Evaluate the diagnostic alarms and eliminate the
error.
To correct or avoid errors
Check the supply voltage.
•
Check the BaseUnit type and the wiring of
•
the BaseUnit.
---
Check the encoder wiring.
•
Check the loads connected to the encod-
•
er supply.
Check the supply voltage.
•
55