Huawei SmartLogger2000 User Manual page 195

SmartLogger2000-(10-C, 11-C)
User Manual
Alarm Alarm
ID Name
1105 Device
Address
Conflict
1106 AC SPD
fault
1107– DI1
1114 custom
alarm–DI8
custom
alarm
24V
1115
power
failure
Issue Draft A (2017-02-15)
Alarm Alarm
Severity Sub-ID
Major 1
Major 1
Major 1
Major 1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Cause Measures
The  If the SmartLogger RS485 address
SmartLogger conflicts with the physical address for
RS485 address the connected southbound device,
conflicts with choose Settings > Modbus TCP and
the physical change the SmartLogger address, or
address (RS485 choose Maintenance > Device Mgmt. >
address) or Connect Device and change the
logical address southbound device address. If the
for the southbound device is a SUN2000, you
connected can change its address on the app.
southbound

If the SmartLogger RS485 address
device.
conflicts with the logical address for the
connected southbound device, choose
Settings > Modbus TCP and change
the SmartLogger address.

The SPD in the Check whether the cable to the SPD in
smart array the smart array controller is loose,
controller is disconnected, or connected in reverse. If
faulty. so, reconnect the cable securely.

Check whether the SPD in the smart
array controller is faulty. Replace the
faulty SPD.
The dry contact  Check the DI port cable connection. If
signal from the the cable is loose, disconnected, or
peripheral to the connected in reserve, reconnect it
corresponding securely.
DI port on the
 Verify that the relevant device works
SmartLogger is
properly.
abnormal.
The 24 V power  Check whether the cable to the 24 V
module in the power module in the smart array
smart array controller is loose, disconnected, or
controller is connected in reverse. If so, reconnect the
faulty. cable securely.
 Check whether the 24 V power module
in the smart array controller is faulty.
Replace the faulty power module.
9 Device Maintenance
187