07/2017
1018663-00
4.10
Cleaning or replacing UV lamps and
filter panels in the canopy
–
Removing the canopy panel: see page 44.
The following components listed in the maintenance plan are fitted in the
canopy:
1.80 m UV low pressure lamps
Facial tanner UV low pressure lamps and the associated starters
Facial tanner UV high pressure lamps
Facial tanner filter panels
These devices have 3 UV low pressure lamps in the facial tanner.
The facial tanner's UV low pressure lamps must be removed first so that the
UV high pressure lamps can be changed.
–
Remove the lamps.
–
Remove the two upper low pressure lamps in the canopy so that you can
then access the facial tanner's low pressure lamp starter.
Replacing lamps: see page 49.
Replacing starters: see page 50.
UV high pressure lamps and filter panels: see page 51.
When assembling the device please note:
–
Support the canopy panel with one hand so that it does not fall down.
–
Re-lock the locks: first the lock in the middle, then the outer locks.
–
Remove fingerprints and other soiling carefully.
Cleaning and maintenance
Operating instructions – 53/68