Cleaning and maintenance
52
5.9
Cleaning or replacing UV lamps in the
base
–
Lift up the acrylic glass panel and then remove the lamp covers and the
partition: see page 45.
Replacing the lamps: see page 48.
Replacing the starter: see page 50.
The assembly is the same process in reverse order.
When assembling please note:
–
Clean the partition.
–
Hold the partition with a cloth in order to prevent finger prints.
5.10
Cleaning or replacing UV lamps and
filter panels in the canopy
–
Removing the canopy panel: see page 46.
The following components listed in the maintenance plan are fitted in the
canopy:
1.80 m UV low pressure lamps
Facial tanner UV high pressure lamps
Facial tanner filter panels
Replacing the lamps: see page 48.
Replacing the starter: see page 50.
UV high pressure lamps and filter panels: see page 50.
The assembly is the same process in reverse order.
When assembling the device please note:
–
Support the canopy panel with one hand so that it does not fall down.
–
Refit and retighten the screws. Refit the middle screws first and then the
outer screws.