Log Printing Message Configuration - Zte W800A Installation Instructions Manual

3.
Parameter Name
{simple_mode|
gateway_mode }

3.4.15 Log Printing Message Configuration

1.
2.
Parameter Name
{Lowest|Lower|
Higher|Highest}
3.
l2-separate mode
Command mode: Configure mode
Function: Configuring the two-layer separation working mode.
Command format: l2-separate mode {simple_mode | gateway_mode }
Parameter descriptions:
Value Range
simple_mode,
gateway_mode
logmsg all-enable
Command mode: Configure mode
Function: Enabling or disabling the log printing messages of all the modules.
Command format: [no] logmsg all-enable
logmsg level
Command mode: Configure mode
Function: Configuring the levels of the log printing messages to be output.
Command format: logmsg level {Lowest|Lower|Higher|Highest}
Parameter descriptions:
Value Range
Lowest (Flood),
Lower (Info),
Higher (Error),
Highest (Fatal)
logmsg mod-enable
Command mode: Configure mode
Function: Determining the module containing the log printing messages.
Command format: [no] logmsg mod-enable <module>
Parameter descriptions:
Chapter 5 Command Line Configuration
Parameter Descriptions
Selecting the simple mode or gateway mode for the
two-layer separation.
Parameter Descriptions
Level of the log printing messages to be output.
Only the printing messages higher than this level
can be output.
3-19