Iapp Load Balance Configuration - Zte W800A Installation Instructions Manual

Function: Exiting the configure mode and entering the privileged mode.
Command format: exit

3.4.10 IAPP Load Balance Configuration

1.
Parameter Name
<value
<vlaue
<vlaue
2.
Parameter Name
{disable|balance|
max-user}
&
Configurations iapp balance and iapp max-user can not be enabled at the same time.
iapp balance
Command mode: Configure mode
Function: Configuring the load balance mode and nominal capacity of the load
balance group.
Command format: iapp balance <vlaue
Parameter descriptions:
Value Range
1
> 1~65535
2
> 1~65535
3
> 1~30
iapp enable-flag
Command mode: Configure mode
Function: Configuring the enabling status of the load balance and the limitation
of the maximum user quantity.
Command format: iapp enable-flag {disable|balance|max-user}
Parameter descriptions:
Value Range
Disable,
Balance,
max-user
Note:
Chapter 5 Command Line Configuration
1
> {flow <value
Parameter Descriptions
Load balance group ID
The lower limit of the flow implementing the load
balance according to the data flow.
The lower limit of the users implementing the load
balance according to the user quantity.
Parameter Descriptions
disable: Disabling both of them.
balance: Enabling the load balance.
max-user: Enabling the limitation of maximum user
quantity.
3-15
2 3
>|user <value > }