Table of Contents
Advertisement
ZXR10 WAS (V2.0) IP Wireless Access System W800A Wireless Access Point
Professional Installation Instruction Manual
7.
CLI provides two layers of password protection to reject illegal users. The first
layer password authentication appears on the Telnet welcome interface, the
safety authentication for accessing the user mode is required at this time. The
default user name is "root" and default password is "public". In the user mode,
input the enable command and correct password to enter the privileged mode,
the default password is "zte".
&
Notes:
When you implement the configuration in the serial port mode, you can enter the user
mode from the hyper terminal interface directly, without any authentication.
8.
CLI can automatically page the output commands on the terminal: "—More—"
at the lower left corner of the command output window indicates more output
commands. At this time, you can press CTRL to display the next page, press
ENTER to output the next line and press other keys to exit.
9.
W800A CLI provides the basic command line editing function. The short-cut
keys for editing command lines are described as follows:
Ctrl + U: Delete the whole command being input.
Ctrl + A: Move the cursor to the first character of the command line.
Ctrl + E: Move the cursor to the last character of the command line.
Ctrl + X: Delete all the characters before the cursor.
Ctrl + K: Delete all the characters after the cursor (containing the character at
the cursor)
Ctrl + C: Give up all the input contents. Enter the new line and the prompt character
will appear.
When the serial port mode is used for configuring the W800A, the serial port attribute
configurations of the hyper terminal are shown in Fig. 3.-1.
3-2
Advertisement
Table of Contents
