Lubrication - Suzuki RM250 Owner's Service Manual

I
PERIODIC MAINTENANCE 2·14
LUBRICAT ION
Apply grease or oil to the moving parts to increase durability and prevent wear.
No. ITEM LUBRICANT FREOUENCY COMMENTS
1. Inner cable A
Pre-race and between
Run oil through cables. Unit
it
ends. lever
every
race
exists the lower end. Lube the
cable ends where they pivot.
2.
Throttle grip ,
A Pre-race Lightly
oil the inside of throttle
throttle hous-
spool, Keep free from dirt.
inQ, cable
3.
Rear brake C
Pre -race
Grease the brake pedal pivot.
pedal
4.
Swing arm
C Every 3 races/ More
Clean and pack the bearings.
often according to con-
Keep seals fresh.
ditions
5.
Rear suspen-
C Every 3 races/More Clean and pack the bearings.
sian linkage often according to con- Keep seals fresh .
pivot points ditons
6 .
Steering stem C Every 5 races/More Clean and pack the bearings .
bearings often according to con- Keep seals fresh .
ditions
7. Choke/idle
A
Pre-race
Lightly oil the choke/idle adjust
adjust knob knob shaft.
8.
Drive chain B Pre-race and between Keep chain thoroughly lubed at
every moto all t imes. Always check wear
and alignment.
The following materials are necessary:
A. Lightweight oil such as WD-40 or penetrating oil.
B. Aerosol type Suzuki Chain Lube or equivalent lube.
C. Water-proof wheel bearing grease.
Follow the schedule closely. The disassembly necessary to lubricate many components is in itself
valuable preventative maintenance. It allows you to inspect for wear, fatigue, adjustment and fastener
tightness and it allows you to clean out the grit which otherwise cannot be gotten out.