Suzuki RM250 Owner's Service Manual page 118

15·10 fRONT fORK AND STEERING
• Apply the thread lock 1303 to the inner rod thread .
• Make sure the push rod
<D
is in the inner rod .
• Anach the sealing washer
®
to the center bolt and in-
sert the
a
shaped projection
®
of center boh into the
push rod
0 ,
• Turn the cent er bolt clockw ise until the end of inner rod
is fully inserted into the center bolt. Tighten the lock nut
to the center bolt .
Tightning torque 2 .0 kg-m
A
WARNING
Front fork will be broken if the inner rod is not correctly
tightend .
In sert the inner rod fully into the center bolt before tight-
ening the lock nut.
• Apply thread lock 1303 to the center bolt thread
• Remove the stopper plate whi le pressing in the fork cap
bolt . Tighten the center bolt to the inner tube.
Tightening torque 6 ,5 kg-m
• Release the front fork from the vise and hold it vertically .
• Fit the fork cylinder holder on the fork cap and tighten
it to the outer tube thread .
09943-74'" Front Fork Oil level Gauge
09940-428'0 Fork Cylinder Holder
NOTE: Cut the hatched 8re8 of the special tool to set it
on the front fork.
Inner rod
lock nut
Cefller bolt
NG
25 mm
o