Printgo-Gate /Print Start Control; Figure 152 - Printgo-Gate /Print Start Control - Leibinger JET3 up Operating Manual

Group 8
8.5.2.9 PrintGo-Gate - Print start control
This function offers an additional option to control the print start. With this
function enabled the printout starts only as long as the monitored sensor is active
during the PrintGo signal.
The inputs for the sensor signals are located on the connector of interface X5 of
the LEIBINGER JET3up.
Figure 152

PrintGo-Gate /Print start control

Activating options:
 High-Level active:
 Low-Level active:
JET3up
Gate
PG signals
Gate
PG signals
Job Editor Page 275
Signals are
not
processed
Release R1.06